Whirlpool appliances use a dual-code system combining F (Function) and E (Error) codes to pinpoint specific problems. Understanding these codes can save you time and money by helping you determine whether a simple fix will work or if professional repair is needed.
Whirlpool Washer Error Codes
F5 E2 — Door Lock Error
The washer can't lock or unlock the door. Fix: Check for obstructions in the door latch area. Try a power reset. If the error persists, the door lock assembly needs replacement. Read our detailed F5 E2 guide.
F9 E1 — Long Drain Error
The washer is taking too long to drain. Fix: Check the drain hose for kinks. Clean the drain pump filter. Ensure the drain hose isn't inserted too far into the standpipe (maximum 8 inches).
F8 E1 — Water Supply Error
The washer isn't detecting enough water flow. Fix: Verify both hot and cold supply valves are fully open. Check inlet hose screens for sediment. If the error persists, the water inlet valve may need replacement.
F7 E1 — Motor Speed Sensing Error
The motor can't achieve the correct speed. Fix: Check for an overloaded drum. If the load size is normal, the motor control board or motor itself may need professional attention.
Whirlpool Oven/Range Error Codes
F2 E1 — Oven Temperature Too High
The oven has exceeded safe temperature limits. Fix: Cancel the current cycle and allow the oven to cool. If the error recurs, the oven temperature sensor or control board may be faulty. Read our detailed F2 E1 guide.
F3 E2 — Oven Temperature Sensor Open
The temperature sensor circuit is broken. Fix: The sensor probe (usually at the top rear of the oven cavity) needs testing and likely replacement. This is a common and affordable repair.
F9 E0 — Door Lock Error (Oven)
The oven door lock mechanism has failed, usually during or after a self-clean cycle. Fix: Try a power reset. If the door remains locked, the lock motor or switch may need replacement.
Whirlpool Dishwasher Error Codes
F8 E4 — Water Supply Error
The dishwasher isn't getting enough water. Fix: Check the water supply valve under the sink. Inspect the inlet hose and float switch.
F2 E2 — Long Drain Error
The dishwasher can't drain within the expected time. Fix: Clean the filter assembly. Check the drain hose and garbage disposal connection.
Whirlpool Dryer Error Codes
F1 — Control Board Error
The main electronic control board has detected an internal fault. Fix: Try a power reset. If the error returns, the control board likely needs replacement — a job for a professional technician.
AF — Restricted Airflow
The dryer has detected restricted exhaust airflow. Fix: Clean the lint trap and entire exhaust duct. Check the exterior vent for blockage.
Need Help?
Whirlpool's F/E code system is designed to help technicians quickly identify problems. If you've tried the basic fixes and the error persists, call RapidFix at (754) 888-5560 for professional Whirlpool appliance repair in South Florida.
